跳到主内容
Ciallo
Back to games & experiments

电场线与带电粒子

点电荷电场线分布,以及平行板中粒子的类平抛偏转。

E = U/d类平抛

Try the experience, then read the guide. Pausing keeps your state; resetting clears the current session and parameters.

Try a different scene

Loading a preset restarts the experiment and applies its parameters. You can fine-tune them afterwards.

Preparing the experience…

UNDERSTAND EVERY MOVE

电场线与带电粒子 · Detailed guide

观察带电粒子以水平初Speed进入平行板电场后的偏转。水平方向Speed与竖直方向电场力共同决定轨迹。先读清粒子的电荷符号和电场方向,再判断它向哪块板偏,不把电子和正电荷混为1谈。

Getting started

  1. 01先选择带电粒子模式,或载入轻微偏转预设,观察粒子通过板间的轨迹。
  2. 02增大偏转电压,Comparison偏转程度。
  3. 03保留电压,增大水平Speed,观察偏转是否减小。

Controls & parameters

  • 偏转电压U单位V,板间距在Experiment中固定,电场强度about为U/d。
  • 入射Speed滑块以×10⁶m/s显示,代入计算前需还原单位。
  • 轨迹是简化理想电场模型,接触板面后不应继续当作自由飞行。

F=qE,a=qE/m

电场力方向由电荷符号决定,电子受力与电场方向相反。板间忽略边缘效应时,可把E近似为均匀量;水平无电场力时,水平Speed保持。

飞行时间决定偏转

板长为L时,通过板间的时间about为t=L/v₀,竖直偏移y≈½at²。因此其他entries件相同,v₀翻倍时偏移about变为4分之1;电压增加会增大加Speed,但过强时粒子可能先碰板。

Strategies & observations
  • 先Comparison未碰板的轨迹,否则终止entries件会影响观察。
  • 分清电场方向和电子受力方向。
  • 保持板间距和板长不变后,再检验U与v₀的影响。
Common misconceptions
  • 入射Speed数字带×10⁶倍数,不能当成几m/s。
  • 这是非相对论、均匀电场近似,不包含边缘电场和真实束流效应。

Put your understanding into practice

completed0 / 3

Follow the steps, compare the expected results, and mark the challenge complete yourself. This records your practice without judging your results.

CHALLENGE 01

电压翻倍

  1. 选两组均可通过板间的电压。
  2. 保持入射Speed不变Comparison偏移。

Expected result: 电压较大时偏移更大,未触板范围内近似成正比。

CHALLENGE 02

Speed翻倍

  1. 保持电压,使用2与4×10⁶m/s。
  2. Comparison板出口附近的偏移。

Expected result: 较快粒子的偏移about为较慢粒子的4分之1。

CHALLENGE 03

解释碰板

  1. 逐渐增加电压或降低入射Speed。
  2. 观察轨迹何时不再通过板间。

Expected result: 能说明是电场加Speed和通过时间共同导致碰板。

Explore similar experiences

Contact Ender

Say hello, discuss a commission, or send a little kindness. Here's where to find me.

© 2026 Ender · Cat Garden