串联与并联
串联总电阻为R₁+R₂,各处电流相同,电压按电阻分配。并联时1/R=1/R₁+1/R₂,各支路端电压相同,总电流是支路电流之和。电流不是穿过1个电阻就被消耗掉。
切换串联/并联,看电流如何分流、电压如何分配。
Experiment workspace
Try the experience, then read the guide. Pausing keeps your state; resetting clears the current session and parameters.
Loading a preset restarts the experiment and applies its parameters. You can fine-tune them afterwards.
UNDERSTAND EVERY MOVE
在串联与并联之间切换,Comparison电阻、电流、端电压和功率。先看连接方式,再看各支路读数;同时保留电源内阻的影响,避免把电动势与负载端电压永远当成同1个数。
串联总电阻为R₁+R₂,各处电流相同,电压按电阻分配。并联时1/R=1/R₁+1/R₂,各支路端电压相同,总电流是支路电流之和。电流不是穿过1个电阻就被消耗掉。
总电流可用I=ε/(R外+r)计算,端电压U=ε−Ir。外部电阻变小后,总电流增大,内阻上的电压损失也可能变大。外部功率应使用负载实际电压或电流计算。
Follow the steps, compare the expected results, and mark the challenge complete yourself. This records your practice without judging your results.
CHALLENGE 01
Expected result: 总电阻40Ω,总电流0.3A。
CHALLENGE 02
Expected result: 总电阻10Ω,总电流1.2A,每支路0.6A。
CHALLENGE 03
Expected result: 电流和负载端电压均下降。
Say hello, discuss a commission, or send a little kindness. Here's where to find me.
© 2026 Ender · Cat Garden
左右滑动画布Explore完整图形与标注。