跳到主内容
Ciallo
Back to games & experiments

弹力与胡克定律

弹簧挂砝码测伸长,右侧同步画 F–x 图。

F = kx弹性限度

Try the experience, then read the guide. Pausing keeps your state; resetting clears the current session and parameters.

Try a different scene

Loading a preset restarts the experiment and applies its parameters. You can fine-tune them afterwards.

Preparing the experience…

UNDERSTAND EVERY MOVE

弹力与胡克定律 · Detailed guide

用砝码产生拉力,观察弹簧伸长和F–x关系。重点是区分弹簧的劲度系数、砝码质量与伸长量:更重的负载增加力,更硬的弹簧则在相同力下伸得更少。

Getting started

  1. 01固定单个砝码质量,逐个增加砝码。
  2. 02记录总重力与伸长,ComparisonF/x是否稳定。
  3. 03保留相同负载,把劲度系数调大,再观察伸长。

Controls & parameters

  • 劲度系数k单位N/m,数值大表示同样伸长需要更大力。
  • 砝码个数乘单个质量得到总质量,重力about为mg。
  • 显示的伸长是相对自然长度的增加量,不是弹簧总长度。

F = kx

在线性弹性范围内,弹力大小与伸长量成正比。静止悬挂时,弹力与砝码重力平衡,故x=mg/k。把k翻倍、质量不变,伸长就减半。

模型的适用范围

真实弹簧超过弹性限度后可能永久变形,F与x不再保持线性。Experiment中的线性图线用于理解胡克定律,不能凭画布仍然显示1根弹簧就认定所有大负载都安全。

Strategies & observations
  • 先保持k不变作F–x对照,再保持F不变Comparison不同k。
  • 用米作为伸长单位,别把厘米数直接代入N/m。
  • 图线斜率ΔF/Δx对应k,画面弹簧圈数不是k的测量。
Common misconceptions
  • Comparison的是伸长量,不是总长度。
  • 线性关系有物理适用范围,不能外推到真实弹簧任意负载。

Put your understanding into practice

completed0 / 3

Follow the steps, compare the expected results, and mark the challenge complete yourself. This records your practice without judging your results.

CHALLENGE 01

质量翻倍

  1. 使用1个0.5kg砝码记录伸长。
  2. 改为两个同样砝码。

Expected result: 同1k下伸长about翻倍。

CHALLENGE 02

硬度翻倍

  1. 保持负载不变。
  2. 把k由50调到100N/m。

Expected result: 伸长about减半。

CHALLENGE 03

反算劲度

  1. 记录1次F与x。
  2. 用F/x反算并对照滑块。

Expected result: 计算结果与设置的k1致。

Explore similar experiences

Contact Ender

Say hello, discuss a commission, or send a little kindness. Here's where to find me.

© 2026 Ender · Cat Garden